FlywingRC Support

FAQ of Flywing H1 Flybarless Controller

Why can’t I run the helicopter? Turn the stop switch, the motor does not turn？

Because this is a flight controller, you need to unlock the outer eight before you can dial the motor start switch (before unlocking, you must ensure that the motor switch is in the stop position to unlock. After the unlock flashes, dial the run swit

My Helicopter is an old Align model, and it uses a green Phoenix ESC. Why is it useless to increase the speed on the flight controller?

This is the characteristic of Phoenix ESC itself. You need to connect the Phoenix ESC to the computer to set the speed. By default, the Phoenix ESC has only two states: completely stopped and running at full speed, so your helicopter rotates at a ver

I supply BEC power (including 2s battery function) and plug it into the receiver, why the servo is weak?

The H1 flight controller is internally stabilized and then sends power to the receiver. That is to say, if the power supply cannot be poured into the flight controller from the receiver, it will cause the flight controller to burn, which is explained

Should I set the stop switch on my transmitter？

No need, the flight controller thinks that your 3 channels are pitch control and 7 channels are motor control. If you cut down the 3 channels, the collective pitch becomes -12 degrees and the lock is completely locked. Unable to fly, or directly hit

I removed the blades and run the helicopter to test , why can’t I do that？

The flight control has take-off detection (with propeller detection). It is invalid to run it on the table without the blade. Either the servo does not move or it moves randomly.

Why is the flight controller not corrected after correct debugging？

The swashplate was completely armed before taking off without disarming. As long as it is debugged correctly according to the prescribed steps, the correction of the flight control will be correct automatically. Don’t worry here.

Why the swashplate servo do not move? Only the tail servo move.

This flight controller is in GPS mode or automatic flight mode (controlled by five-channel and 8-channel switches), the swashplate servo is not moving. The swash plate servo will only move when the mode switch of channel 5 is switched to 3D mode.

Why flight controller light is red flashing after testing complete？

Because compass is not calibrated, the flight controller light is red flashes slowly. After the compass is calibrated, restart the helicopter , the red light will not flash.

FlyWingRC 450 GPS signal Flashing Yellow/Won't Acquire Signal

If you are having issues with your FlyWingRC 450 H1V2 not receiving GPS signal, please follow the steps below. The link for the Software is at the bottom of this page.LINK FOR SOFTWARE NEEDED